#TIMBERTECH VS TREX REDDIT MANUAL#

Use a long straight edge or a taut string to determine if the board is straight. If a single board is not installed straight this will cause issue with each following board. It does not cause any structural damage or loss of integrity to the deck board. The head of the screw must indent into the bottom radius of the deck board. Maybe you just aren’t pushing hard enough. A minimum of 3 boards must be installed side to side to have an accurate measurement. Unless the boards are fastened down to the joists you cannot get the 1/8' measurement.

Boards are not correctly fastened to joists.

Is the clip you are using metal and colored brown. If a 1/8' drill bit can pass through the side to side gap just barely touching the sides you are good. Use of a drill bit is the easiest way to measure the gapping. Because the board is radiused the gap looks larger than it is.

#TIMBERTECH VS TREX REDDIT MANUAL#

Here are some things to look for and possible solutions for any trouble you may be having.Īccording to the TimberTech installation manual side to side gapping should be a minimum of 1/8” to 3/16” The CONCEALoc and any grooved TimberTech do give a 1/8' gap. If you don't make these adjustments, you will get spacing between 3/16th and 1/4 inch! You can beat on it all day and it will never work unless you rout out the board. Both Timbertech and the fastener manufacturer were aware of the problem but had not addressed it. Timbertech should do this themselves if they continue to sell this fastener system. You could also achieve the same thing by beveling the entire board to allow this clearance.

It was time consuming and should not have been necessary but it worked and our decking now has even, precise 1/8' spaces between each board. Now, the deck board will seat easily when attached to the fasteners. The fasteners were manufactured to Timbertech's specs but the screw even when screwed in at the suggested 45 degree angle sticks out farther than the spacer! Our solution, after discussing this with Timbertech and verifying that it won't cause issues with the decking later, was to rout out a small area in the decking directly where the screw makes contact with the next board. After talking with both Timbertech and the manufacturer of the fastener, we now have isolated the problem and also found a solution. Timbertech concealed fastener issue - solution Can I unscrew the screws now and still re-screw in the same holes? I have always heard that is a problem with composite decks. I may be able to unscrew it and get a pry behind it to try to bend it inward. There is a porch wall on the outside so I don't think I can easily bend the 1st board inward if I unscrew the 1st board. I already screwed in the 1st board on the outer edge.

What could be going on? How can I get the 2nd board to be seated all the way so it reaches the gap tab (1/8') so I can get the gap right? Is there something I can try without doing anything like is discussed in the next paragraph? The gap I get is inconsistent, 1/8' at the ends but about 1/4' in the middle. Per manufacturers instructions I raised the 2nd board to engage the fasteners then lay the 2nd board down but I find, even after tapping the board to better engage the fastener, that it is not reaching the fastener's gap tab and so I am not getting the desired 1/8' gap. I went to fasten my first deck TimberTech boards using the TimberTech ConceaLoc hidden fasteners and I am having issues right out of the shoot.

Timbertech vs trex reddit